Sunday, August 18, 2013
Volkswagen wheel Bearing Owners Manual
Wheel bearing housing (steel) and control arm, vehicles with four wheel drive, servicing Note: If a vehicle has to be moved after removing the drive shaft, install an outer joint instead of a drive shaft and tighten to 50 Nm. Otherwise the wheel bearing will become damaged.Rear wheel bearing, pressing out and in with wheel bearing housing installed Special tools, workshop equipment, testers, measuring instruments and auxiliary items
required VAG 1383 A Engine/transmission jack with universal transmission mounting VAG 1359/2. Install press piece -1- with shoulder to bearing, press sleeve -2- with four stepped internal diameters to wheel bearing housing, hollow piston
cylinder -3- with pull rod and special nut -4-.
- Operate pump and pull out the wheel bearing.
1 – Press piece E-5
2 – Press sleeve E-44-1
3 – Hollow-piston cylinder HKZ-15
4 – Special nut E-8-214 and pull rod
required VAG 1383 A Engine/transmission jack with universal transmission mounting VAG 1359/2. Install press piece -1- with shoulder to bearing, press sleeve -2- with four stepped internal diameters to wheel bearing housing, hollow piston
cylinder -3- with pull rod and special nut -4-.
- Operate pump and pull out the wheel bearing.
1 – Press piece E-5
2 – Press sleeve E-44-1
3 – Hollow-piston cylinder HKZ-15
4 – Special nut E-8-214 and pull rod
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.